MIRCOM MIX-4045 Control module for FX400 series

The MIX-4045 Dual Relay Module is an intelligent addressable device designed to be used with a compatible MGC control panel that provides high, reliable and secure information exchange rates through a bi-directional communication protocol.

The MIX-4045 Dual Relay Module controls two independent circuits while using only one module address. The module provides two Form C (SPDT) contacts rated 2A @ 30VDC or 0.5A at 125VAC, individually controlled by the control panel. The contacts are electrically isolated from the fire alarm control panel. The position of each contact is verified by the module at all times. If a contact is not in the required position during standby or active conditions, the panel will report a trouble.

The module has a panel-controlled LED indicator. The LED flashes during normal operation and remains on steadily when the device is in alarm condition.

The address of each module is programmed using the MIX-4090 programming tool. To set the address on this device, disconnect it from the loop or ensure that the loop it is connected to is disconnected from the panel and shorted between the SCL+ and SLC- inputs of the device. Failure to follow any of these steps may change the address programming of sensors previously configured on the loop.

Characteristics

• Up to 240 MIX-4000 Series devices can be connected in any combination, on a single SLC signaling loop.
  
• Mounts in standard 4 inch electrical gang box or double gang rectangular electrical gang box.
  
• The indicator LED provides the status of the module.
  
• Two individually controlled contacts per module.
  
• Each contact with NO, NC and C terminals.
  
• The module checks the position of the contacts. Stuck or inoperative contacts are reported as a problem signal.

Specs