MIRCOM MIX-4030 Addressable thermal detector for FX400

The MIX-4030/MIX-4030-ISO heat detector is a wired intelligent sensor that continuously monitors ambient temperature to report early high conditions caused by a fire condition and communicates with the panel using a fully digital protocol.

The sensor will report an alarm condition when the sampled temperature exceeds 135ºF (57ºC) or 175ºF (79ºC) depending on the operating mode chosen. Excessive temperature increases may also be reported if the detector is configured for flow rate operation. increase (Temperature gradient).

The MIX-4030 / MIX-4030-ISO works with a compatible MGC control panel that provides high, reliable and secure data exchange rates using a bi-directional communication protocol.

The detector is addressed and programmed using the MIX-4090 handheld device. Addresses can be selected from a range of 1-240. This detector is shipped with a dust cover to protect the device during installation and prior to commissioning. Two tri-color LEDs on the device provide 360 ​​degrees of visibility of the operating condition. A remote LED indicator can be connected directly to the sensor.

Characteristics

• Up to 240 MIX-4000 Series devices can be connected in any combination, on a single SLC signaling loop.
• Different LED colors for Alarms and Troubles.
• Three heat detection operation modes.
  
• Compatible with the full range of MIX-4000 Series control modules and input modules.
  
• The device can be protected by a unique tamper protection mechanism.
  
• The address is programmed using the MIX-4090 handheld device.
  
• OPTIONAL MODEL - with built-in short circuit isolator (MIX 4030- ISO).
  
• Modes of Operation
  • Temperature gradient detection 15ºF/Minute 10ºC/Minute).
  • Fixed temperature detection (135ºF/57ºC).
  • Fixed temperature detection (175ºF/79ºC).

Specs