FIRE-LITE HPF-PS6E Power Supply to Extend NAC 6amp 24v

The HPF-PS10E is a 6 amp remote power supply, with battery charger that can be connected to any 12 or 24 volt fire alarm control panel (FACP), or used as a stand-alone power supply. The HPF-PS Series provides 24 VDC power for notification appliance circuits (NACs) configured as Class B or Class A (requires ZNAC-PS option card) with multiple synchronization protocol options. The HPF-PS Series also provides auxiliary power, either constant or resettable, suitable for detectors, annunciators, door holds, and other fire alarm system peripherals. The HPF-PS Series cabinet can hold two 7 AH or 18 AH batteries and can charge up to 33 AH in a separate cabinet.

Models HPF-PS6E and HPF-PS10E are rated for 240V operation.

Features and benefits:

• Up to seven independently configurable power-limited output circuits for:
• – NAC class B and/or class A
• – 24V auxiliary power supply, resettable or non-resettable, class B and/or class A
• – electric door support
• Converts Class B wiring to Class A without losing any outputs.
• using the ZNAC-PS converter card (sold separately)
• Ideal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power.
• Configurable for ANSI® Temporal 3 or Temporal 4 coded output
• UL Listed NAC Synchronization Using System Sensor®, Wheelock®, Gentex® or AMSECO® Devices
• Synchronization can be activated from the FACP's remote synchronization/NAC outputs, a cascaded power supply, or a single or multiple control module, which may be housed within the power supply cabinet.
• Ability to cascade up to four levels.
• Three fully isolated input/control circuits that can be programmed for any output
• Two Form C normally closed trouble relays for AC trouble and general trouble. Ground fault relay available on Canadian models only
• Full load output of 6 amps respectively with a maximum of 3 A/circuit
• Individual NAC power and trouble LEDs for diagnostic efficiency
• Problem History Modes for Diagnostic Support
• Wide range end-of-line supervision value (typical: 2K-27K ohms)
• Selectable ground fault detection (enable or disable)
• AC Trouble Report Delay Timer
• Fully configurable via integrated DIP switches, without additional software
• requested
• Self-contained in a compact lockable cabinet constructed of heavy duty steel
• gauge steel with a corrosion resistant powder coat and
• Scratch resistant finish
• Cabinet designed with ten double holes and one pull-out drawer.
• Door for easy installation and wiring.
• Includes integral battery charger capable of charging up to 33 AH
• Batteries
• The cabinet can hold two 7 AH or 18 AH batteries